Note that the pups have been replaced with what may be fender? The pick guard was hand made, the pockets for the pups were routed out and they did a pretty good job. The finish on the back is nasty. This will need to be disassembled, sand the body down to bare wood and refinished. Note the back of the neck at the pocket where it was sanded down. The action is low and clean, no buzz at all. I played a few notes with the 3 strings and it sounds pretty good. Separate volume knobs for neck and bridge with a common tone control. I got a close up of the tuners so if anyone has a spare tuner, I could use one. Otherwise I'll end up getting a set of four and pay more for them than I paid for the whole guitar and case.