4th build

Thanks for the interest so far.
This kit came to me at a discounted rate and I have another kit on the go at the same time so I'm planning on treating this build in a light hearted way. That means while I'll give it my best re parts and finish the intended final presentation won't be traditional.
Sorry Adrian I know you lost your stash of Gasket porn, unfortunately your credit card details didn't match my bank requirements so pants will be worn.
 
At it again today, cut the headstock shape, ATT intend doing the same as recent resonator project (second photo).

20181015_162648.jpg
DSC02939.JPG

Created relief for right arm and spreading middle bit :-(

20181015_164433.jpg

Yesterday filled the step at neck to body joint.

20181015_162130.jpg

Finally put a light coat of seal / primer onto the "fluffy" timber.
Going to do most of the before paint finish prep after it's primed, the grain just keeps standing up, I'll fix that :-)
 
gasket said:
At it again today, cut the headstock shape, ATT intend doing the same as recent resonator project (second photo).

View attachment 18734
View attachment 18735

Created relief for right arm and spreading middle bit :-(

View attachment 18736

Yesterday filled the step at neck to body joint.

View attachment 18737

Finally put a light coat of seal / primer onto the "fluffy" timber.
Going to do most of the before paint finish prep after it's primed, the grain just keeps standing up, I'll fix that :)
Click to expand...
Nice work!!
 
smitty_p said:
Really nice progress!

What kind of glue did you use for the neck joint?
Click to expand...

What did I use, NECK GLUE, haaa haaa.

Couldn't resist that dumb answer. Fact is this and the previous build each came with a small plastic bottle of the suppliers recommended glue and it's unlabeled. The first neck I set I used an industrial strength glue that works on anything even glass, was overkill.
 
You must log in or register to reply here.
Back
Top