Ok, The CTS pots require a special knob:
Tolerance = +/- 9%
Can Size = 23.8mm (15/16 in.) radius X 9.5mm (3/8 in.) height
Bushing Threads = 3/8-32
Bushing Height = 9.5mm (3/8 in).
Shaft Type - split
Shaft Diameter = 9.5mm (please ensure that the pickguard / control plate that the pot is mounting onto has a 9.6mm diameter hole)
Spline Count = 24 (NOT metric)
Length of threaded shaft - 9.5mm (3/8 in.)
Value = 550K Ohms
No problem...I found some witch hats that I drilled out to fit:
Then I found these black & silver speed knobs!!!!
Not quite sure which ones I like better, but I did order a set of Kluson nickel pointers already...
Hmmm...is it just me, or do the aged switch tips look out of place????
Tolerance = +/- 9%
Can Size = 23.8mm (15/16 in.) radius X 9.5mm (3/8 in.) height
Bushing Threads = 3/8-32
Bushing Height = 9.5mm (3/8 in).
Shaft Type - split
Shaft Diameter = 9.5mm (please ensure that the pickguard / control plate that the pot is mounting onto has a 9.6mm diameter hole)
Spline Count = 24 (NOT metric)
Length of threaded shaft - 9.5mm (3/8 in.)
Value = 550K Ohms
No problem...I found some witch hats that I drilled out to fit:
Then I found these black & silver speed knobs!!!!
Not quite sure which ones I like better, but I did order a set of Kluson nickel pointers already...
Hmmm...is it just me, or do the aged switch tips look out of place????
Last edited:
