Jackson San Dimas - Yellow Guitar 2 Project:

Inspector #20

Inspector #20

Ambassador of Tone
Fallen Star
Country flag
Thinking that I am going to convert the Jackson to Yellow Guitar #2.

Yellow Paint Job - Same Color as #1, but with Catalyzed Polyurethane Clear

Warmoth Custom Quartersawn Roasted Maple Neck, 1-3/4" Nut Width, 1.00" Soft V Profile

R5 Nut

DiMarzio 'Neanderthal' in the bridge

Custom Wound Bar Magnet/Screw Pole Single Coils - Hum Cancelling

20210109_104203.jpg
 
So now I am thinking.....

Get the Warmoth body shown above...have them make me an 1-3/4" wide R5 nut neck, strip the Jackson down and use the pickguard and all the hardware/electronics and sell the hulk to recover some of the investment...
 
Look closely and you may see the thin, red stripe on the Jackson's custom pickguard...
 
Last edited by a moderator:
Robert Herndon said:
Thinking that I am going to convert the Jackson to Yellow Guitar #2.

Yellow Paint Job - Same Color as #1, but with Catalyzed Polyurethane Clear

Warmoth Custom Quartersawn Roasted Maple Neck, 1-3/4" Nut Width, 1.00" Soft V Profile

R5 Nut

DiMarzio 'Neanderthal' in the bridge

Custom Wound Bar Magnet/Screw Pole Single Coils - Hum Cancelling

View attachment 58651
Click to expand...
Im gonna need a minute....................................................................................................................no...........ssshhhhhhhhhhhhhhh
 
The more I think about this, the more tempted I am to put the CBS headstock, custom Warmoth 1-3/4" neck on the Jackson, even without the locking nut.

It would fare no worse than the stock Fender tremolo and has the benefit of fine tuners...
 
You must log in or register to reply here.
Back
Top