Interesting ----Guitar of the Day

They DIDNT EVEN mention one of the QUIRKIEST gibbos of all
FIREBIRD X
RBFBXRECHP-Finish-Shot-jpg.aspx

I was never a Pontiac guy....
 
WOrked for Danelectro for yeas........particle board..plywood......formica.....whatever they found in dumpsters.....

One of the best-sounding Les Pauls I ever owned was a Studio Lite. Everything about the specs screamed "crappy tone" - it had a balsa wood center block and ceramic pickups. And I would put it up against anything I have ever played for sound quality. Kinda miss it actually.

1993-GIBSON-USA-LES-PAUL-STUDIO-LITE-BLUE-90-s-American-LP-Light-withCASE-01-ymk.jpg


Yes, that was my actual guitar from it's eBay listing. I sold it to Atomic music.
 
One of the best-sounding Les Pauls I ever owned was a Studio Lite. Everything about the specs screamed "crappy tone" - it had a balsa wood center block and ceramic pickups. And I would put it up against anything I have ever played for sound quality. Kinda miss it actually.

1993-GIBSON-USA-LES-PAUL-STUDIO-LITE-BLUE-90-s-American-LP-Light-withCASE-01-ymk.jpg


Yes, that was my actual guitar from it's eBay listing. I sold it to Atomic music.

Are you sure the center block was balsa?

I have a hard time believing balsa would support the stress on the stop bar for any appreciable length of time.
 
Are you sure the center block was balsa?

I have a hard time believing balsa would support the stress on the stop bar for any appreciable length of time.

100% sure. It was very obvious when you pulled the PuPs or opened the control cavity. I suspect they left a section of hog under the bridge and tailpiece like with the chambered guitars for strength, but the middle was definitely a chunk of balsa (They called it "chromyte" in the marketing stuff). There is a small blurb in this listing: Gibson Les Paul Studio - Wikipedia

Either way, it was great-sounding solution to the weight problem. If I run across one of these guitars again I may just snatch it up.
 
The pots dated 5/1977. The good news the pickups were changed to early patent # pre T-tops. And I got the original case and guitar.
The frets are mint never played. Ebony finger board. Maple body and neck. Well not free I watched a friends house for a few months.
 
Plexi.........would you like to REGIFT said RD?????? I dont recall a B-day present from you in Feb....you can atone for this indiscretion without malice or prejudice at this time by sending the RD post haste :) :)
 
100% sure. It was very obvious when you pulled the PuPs or opened the control cavity. I suspect they left a section of hog under the bridge and tailpiece like with the chambered guitars for strength, but the middle was definitely a chunk of balsa (They called it "chromyte" in the marketing stuff). There is a small blurb in this listing: Gibson Les Paul Studio - Wikipedia

Either way, it was great-sounding solution to the weight problem. If I run across one of these guitars again I may just snatch it up.

Fascinating.
 
Back
Top