Finishing New Bass Body

Cadorman

Cadorman

Ambassador of the Catocaster
Country flag
20191017_195805.jpg

Alright, I'm getting ready to start the finishing portion of my new bass build. I'm going to grain fill with ebony filler. Use some combination of red/yellow stain and then Tru Oil for a finish. Products used are in the picture. The body is roasted swamp ash.

Question: What do I clean the body with before using the grain filler?
 
Cadorman said:
Question: What do I clean the body with before using the grain filler?
Click to expand...
I like naptha for this purpose. It is also good to cut the true oil with naptha. Here is a procedure I found in a Yputube comment and have followed with great success



I've been a Professional Restoration, Finishing & Painting Contractor since 1980, the Summer I Graduated High School. I used to help my Dad & Grandad from 12 years old onwards and I've used just about every kind of Coating there is. I'd like to make a few suggestions to help you. First use VM&P Napthia (Varnish Makers & Painters) instead of Mineral Spirits. (Paint Thinner) Napthia is also known as Lighter Fluid such as Ronsonol or Zippo, Coleman Camping Fuel or White Gas (not Gasoline) but VM&P is the best because it's a little cleaner/higher grade. VM&P Napthia will mix in better, your Tru-Oil will set (tack) up quicker, dry faster and cure out a little harder plus being a much higher grade Solvent than Mineral Spirits it will increase the shine. Always measure and stir it in (don't whip, it'll add air bubbles) whatever Solvent you use to thin the Finish you're using. This way you can easily replicate it and you'll have consistently from batch to batch. Try 3 Tablespoons of Tru-Oil & 1/2 Tablespoon of VM&P. If that's too thick add another 1/2 Tablespoon of VM&P. Keep adding VM&P 1/2 at the time until you've got the desired viscosity. Once you've got your ratios down you can replicate the excact same formula over and and your finish will be perfect and consistent. You can make larger batches by using a Shot Glass in the same ratio. If You have a some Baby Food Jars with a good Rubber Seal in their lids. You can mix up a jar full at the time if you have 2-3 Guitars to finish. Even if you don't mix a jar full you can keep your leftovers in a Baby Food Jar. Also it's really best to use your thinned Tru-Oil for your First Coat because it will Soak in and Penetrate Deeper. This will Bond & Seal your Wood better. It won't hurt to use your thinned Tru-Oil for all your Coats, you may find you like this better. The Best Sealer is Zinsser Seal-Coat. It's a 100% wax free Shellac compable under all Clear Finishes, even Hot Solvent Finishes like Lacquer and 2 part Epoxies and Alphatic Urethane. If you Seal your Wood with Zinsser Seal-Coat Your Tru-Oil, Polyurethane, Lacquer, etc. will have greater "Enamel Holdout" (higher gloss/sheen) plus all your Top Coats lay down and smooth out better. Lastly put a little Cyanoacrylate (Super) Glue on the little Cardboard/Paper Seal that comes in your Tru-Oil's Top to keep it in place and store it upside down. This will keep it Fresh longer and if it Skins or Scabs over this Will be on the bottom when you turn it right side up. Hope this Helps you. look for Jimmy Reaves (no picture) on Facebook. I'll send you my email and help you all I can.
 
You must log in or register to reply here.
Back
Top