Amp Foot switch Vol level

[Leedspool]

I recently picked up a foot switch for my vox Vt 30 modelling amp that I can select 8 presets

My issue is when My overdrive channel, going from overdrive to clean the clean channel is too quiet and I have to go to the amp and crank the volume for the clean. This is particularly frustrating well trying to play Radiohead‘s creep. I got the footpedal so I wouldn’t have to mess with the Amp however I’m back to twiddling knobs again.

Any tips on levelling the volume from clean to overdrive for a situation like this would be welcomed

 

[Leedspool]

I may have found a solution !! I found this: looks like I can save Vol but not master vol

GAIN (G) = pre-amp distortion (how clean/dirty the tone is) which is different to valve saturation.
VOLUME (V)= normal Volume, no real effect on tube saturation, setting can be saved
MASTER VOLUME (MV)= overall volume & tube saturation level, setting can't be saved. The higher the MV is set, the more 'tube saturation' (TS). TS is different to G - it gives the overall tone more vibrancy, feel & response. On high gain amp models in particular, overdoing the MV can make tone muddier - between 1-3pm is usually best.
POWER-SELECTOR (PS) = attenuator.