Von Herndon Doubleneck First Video

I felt like the Witch Hats sat too high, due to their flat base:

IMG_20171228_51830.jpg

I swapped them out for a set of recessed base Top Hats and added pointers at 2'Oclock:

IMG_20180127_55670.jpg
I used a 45 degree carbide burr, turned by hand, to get the skirts close enough to the body that you cannot see the retaining nut on the pots.

Thoughts???
 
Robert, what bugs you and what was all that " foul language " edited?

The other day at work,,,,,,,,,,,,, I had to " fix" 1 bloody screw on a Shower faucet handle that would not back out in order to remove the handle and trim plate that keeps the water from getting into the hole behind the diverter.

The solution I came up with was to grind the head off the screw until I could remove the handle.
The next fix was to buy a new Moen Cartridge and handle with screw so the faucet will work properly when I get finished redoing their shower.
 
Robert Herndon said:
I-Pad video, as I am yet to finish the setup of my recording equipment. You will have to bear with the mix, and it sounded better in the music room than it did on the video. Just messing about with a few licks and playing with my DD-3 delay.

Bridge pickup, six-string neck, Thro-Bak SLE-101 8.2kΩ

Marshall DSL40C with 50 Watt WGS Reaper 55 Hz - Full Gain Red Channel - All EQ's at 1/2

Boss DD-3 Delay

Amp is in the closet off to my right and behind me with the door closed - I'm running it pretty loud.


@chilipeppermaniac - I threw in a country lick just for you... :)
Click to expand...

@chilipeppermaniac - Did you work out that country lick at the very start of the video yet???

 
You must log in or register to reply here.
Back
Top