Since taking this guitar back, I was literally stunned at how good it sounded. I recall raiding a Luthier chum's parts bins for the electronics, mostly Epiphone take outside, but I couldn't recall the specifics.
This was one of his Les Paul replicas that was being built at the same time as Mom's black LPC replica:
After breaking a string last night, i opened the LPC replica back up this afternoon:
The switch is a Switchcraft Quick Connect from a Gibson, with the other end soldered in place. The pickups are embossed "Epiphone" with no 'CE' or 'Rohs' stickers on them anywhere. They measure 9.20k/8.96k respectively. It also appears that I installed them backwards because the lower output pickup (with blue wire) is in the bridge:
The gold plated aluminum tailpiece (I put aluminum on all my guitars) is a Faber:

I used large Alpha pots and I noticed that I had soldered in a 275k resistor on the 'hot' side of the bridge pickup - something I learned from Bill Lawrence - and a means of cutting the brightness off the bridge pickup.
Since I plan to use this as a live backup to my 2016 Gibson Les Paul 50's Tribute, I decided to give it a better level and crown.
I made my first pass with #1000 paper on a 12" radius block.
I then crowned with a 3.5mm inverted file and polished by wrapping #2000 paper around the file. I finished up with jeweler's rouge on micro fiber wrapped around the file.
Nice tone from this guitar. Very rich and bell-like...actually...it sounds better clean than my Gibson Les Paul with 498T/496R.
How's your weekend going???
This was one of his Les Paul replicas that was being built at the same time as Mom's black LPC replica:
After breaking a string last night, i opened the LPC replica back up this afternoon:
The switch is a Switchcraft Quick Connect from a Gibson, with the other end soldered in place. The pickups are embossed "Epiphone" with no 'CE' or 'Rohs' stickers on them anywhere. They measure 9.20k/8.96k respectively. It also appears that I installed them backwards because the lower output pickup (with blue wire) is in the bridge:
The gold plated aluminum tailpiece (I put aluminum on all my guitars) is a Faber:

I used large Alpha pots and I noticed that I had soldered in a 275k resistor on the 'hot' side of the bridge pickup - something I learned from Bill Lawrence - and a means of cutting the brightness off the bridge pickup.
Since I plan to use this as a live backup to my 2016 Gibson Les Paul 50's Tribute, I decided to give it a better level and crown.
I made my first pass with #1000 paper on a 12" radius block.

I then crowned with a 3.5mm inverted file and polished by wrapping #2000 paper around the file. I finished up with jeweler's rouge on micro fiber wrapped around the file.
Nice tone from this guitar. Very rich and bell-like...actually...it sounds better clean than my Gibson Les Paul with 498T/496R.
How's your weekend going???