A small project for this evening
- Thread starter Ebidis
- Start date
chilipeppermaniac
Ambassador of Decibels
Boney maroneyyyyyy
Amp Mad Scientist
Ambassador of Heresy
I used to have a Dremel Moto-shop scroll saw sander.
I recall that this was very handy for making nuts, especially the disk sander...
Low budget but it can do a lot for such a cheap tool.
Amp Mad Scientist
Ambassador of Heresy
Show off.
heltershelton
Well-Known Member
great job man, but whats up with the strings?
OP
Ebidis
Ambassador of Cross Legged Tele-Communication
That's the old strings, and I broke the high E. The string in the high E slot is actually the B string. I am just using the old strings to "clamp" the nut in place until the glue sets, and then I will restring it.
heltershelton
Well-Known Member
when i went to the hospital in dallas, they told me they had a new way to install a new heart valve, and it included included some sort of roto rooter type device. an anal roto rooter.
i told him no thanks and split. which is faster than "left".
marshalltsl
Well-Known Member
Good job. Well done.
chilipeppermaniac
Ambassador of Decibels
Don't let the door Hit YA where the Good Lord Split ya!!!!
OP
Ebidis
Ambassador of Cross Legged Tele-Communication
Just strung her up after sitting overnight. She sounds good. No tuning or intonation problems. This turned out as well as I could have hoped for.
I can't tell if it's really made a difference in sound, because I went from old worn in strings to brand new zingy sounding strings.
I can't tell if it's really made a difference in sound, because I went from old worn in strings to brand new zingy sounding strings.
Last edited:
chilipeppermaniac
Ambassador of Decibels
MMMM Zingy yeah baby
syscokid
Ambassador of War & Peace
It's Keith Richards's new tuning setup...
